![]() DO NOT operate your vacuum without these filters. Before using your vacuum, make sure that the Dirt Tank is in locked position and that all filters, both pre- and post-filters, are in place.Turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.Be sure to let it dry completely before placing back in Dirt Tank. Tap separator against inside of trash container and rinse under warm water, if necessary.Twist Cyclone counter-clockwise and pull down to remove.Press the bottom release button to empty. Hold the Dirt Tank over a trash container.We have additional maintenance videos for your machine on. Return the Dirt Tank to the vacuum by securing the bottom in place first and then pushing back until you hear a “click”.Once emptied, snap bottom back into place. Hold the Dirt Tank over a trash bin and press the Empty Button.Press the Dirt Tank Release Button and grab the handle to pull the Dirt Tank away from vacuum.When finished, replace the wand back on the vacuum by sliding into place until you hear a “click” and reattach hose to handle if needed.įor additional maintenance steps, visit.To do so, twist circular hose cuff counter-clockwise and remove from handle. The Stretch Hose can be removed from the extension wand.Push the release button to remove and attach desired tool. Clean hard-to-reach spaces with the Quick Release Extension Wand.Visit to see all the ways you can use your vacuum’s tools. Do not allow plug to whip when rewinding. Warning: Hold plug when rewinding onto cord reel. If it doesn’t fully retract at first, pull some of the cord out and press the button again.Hold the plug and press the Automatic Cord Rewind Button to slowly retract the cord. When you’re done cleaning, unplug the vacuum.To plug in your vacuum, gently pull the cord out, being careful not to pass the red mark on the cord.If you have trouble with this feature, see our troubleshooting videos on. Warning: Do not plug in your vacuum until you are familiar with all instructions and operating procedures. Use the Suction Control Switch to change settings between plush and low carpet for easy multi-surface cleaning.Note: The Brush Roll automatically shuts OFF when vacuum is locked in upright position. Step gently on base and pull the handle back to recline. ![]() Turn the Brush Roll Switch OFF when vacuuming hard or delicate surfaces like hardwood, tile, small area rugs, or frieze carpets with long delicate fibers or threads. Brush Roll is ON when light switch is illuminated. Optional: Turn the Brush Roll Switch ON to run the PowerBrush for carpet cleaning. See other models: 2486 3070 2039A 15441 2592įor additional ways to use your vacuum’s features, check out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |